The test instrument for the new generation of networks
Multi-layer testing for UMTS installation and commissioning
Victoria SDH/ATM/IP is a hand-held tester for the installation, acceptance and maintenance of ATM networks in IP environments and over SDH, SONET or PDH.
- Auto-configuration, to identify the incoming signal
- Terminal, monitor and transparent modes
- One button test, execution of programmed tests
- Counters, rates, time plots and histograms
- Touch-screen and SoftLEDS (C)
It has all ITU-T and Bellcore interfaces up to 155 Mbit/s:
SDH | Sonet | PDH | T-Carrier |
STM1
STM0
G832 | OC3
STS3-3c
STS1 | E4
E3
E2
E1
nx64kbit/s | DS3
DS1 nx56/64kbit/s |
- Tandem Connection Monitoring (TCM) and APid tests
- G.783 pointer sequences
- Automatic Protection Switching (APS)
- Round Trip Delay (RTD) on all interfaces
- PDH PCM30/31 frame structure with CAS signalling
- SDH at 34Mbit/s according to the ITU-T G.832
- Outputs with frequency offsets from 0 to 20000ppm with steps of 0.01ppm
- ATM traffic generation with editing of the overhead and payload
- Tracing of active connections
- CBER bit error tests
- Simultaneous analysis of CTD, 1-CDV, 2-CDV, CMR, CLR, CER, SECBR, SES and US
- End-to-end or segment F4/F5 cells
- AIS, RDI, continuity test and closed loop
- Generation and analysis of AAL1, AAL2 and AAL5
- Ping over ATM
- List of IP addresses, frequency and packet size
- Bandwidth use
- Traffic composition % per protocol: TCP, UDP, ICM, IGMP
- Traffic composition % by application: WWW, FTP, Telnet, DNS, SNMTP.
|
|
|